| Flow
rates based on size markings of Mikuni and DynoJet jets are
not comparable. As a guide .. the
chart to the left indicates equivalent sizes based on the
diameter of hole in the
jet.
Mikuni jets are chamfered on the inside
opening at the threaded end and
Dynojets have a machined
flat surface. Keep this in mind when using this
chart.
These physical differences will never allow an exact
comparison.
This chart is intended to
be used as a tool to assist you in making a
more
accurate decision when selecting a jet size range or
comparing tuning data
where an opposing brand is being
used.
Actual jet sizes are
highlighted with a gray background. | 